Chevron Bracelet

posted May 21, 2014, 6:16 PM by Unknown user   [ updated May 21, 2014, 6:16 PM by JuliaV 87 ]

You’ll need:

  • embroidery thread
  • a safety pin or tape
  • a pair of scissors
How To Make It:
  1. Start by cutting several strands of embroidery thread at about 24 inches each. Make sure there are two sets of each color. Combine the threads and tie a knot, leaving at least 3 inches of slack. Tape it to a flat surface or safety pin it to a pillow. Separate the two sets, arranging the strands in a mirror-image pattern with the outside strands the same color and so on moving inwards.
  2. Start on the left side with the outermost color and make a forward knot by creating a 4-shape over the 2nd color, loop it under and back through the opening.
  3. Pull up and to the right to tighten. Make the same knot twice over each color. Continue knotting over each color, towards the right, until the outermost color has carried over to the middle. This is one half of the chevron pattern.
  4. Now pick up the outermost color on the right side and make a backward knot, creating a reverse 4-shape over the 2nd color, loop it under and back through the opening. Pull up and to the left to tighten. Don’t forget to knot twice over each color!
  5. Continue knotting towards the left until the outermost strand reaches the middle. Tie a backwards knot with the two middle strands to connect the two halves.  The first chevron row is complete! Continue with the the next color, which is now the outermost strand.
  6. Remembering the color order is important for the first few rows but after the 3rd or 4th row, the strands will fall in place. Finish it with a knot and a braid. 
That is how you make a chevron bracelet. Hope you enjoyed!


Comments